LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 4 Of 5)) >> Off-Vehicle Repair Instructions - Part 3 >> Valve Rocker Arm Installation - Left

Valve Rocker Arm Installation - Left

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Valve Rocker Arm
    GM1400021Courtesy of GENERAL MOTORS CORP.
  1. Apply a liberal amount of lubricant GM P/N 12345501 (Canadian P/N 992704) or equivalent to the pivot pocket (1), roller (2) and valve slot (3) areas of the camshaft followers.
    2. Fig 2: View Of Valve Rocker Arm
    GM902907Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.
  2. Place the camshaft followers in position on the valve tip and stationary hydraulic lash adjuster (SHLA).
  3. The rounded head end of the follower goes on the SHLA while the flat end goes on the valve tip.
  4. Clean the camshaft journals and carriers with a clean, lint-free cloth.
scientia non olet · About LEMON Manuals