Camshaft Position (CMP) Actuator Installation - Right Intake

WARNING: This page is about a different variant/trim than selected.

Ensure the proper camshaft position actuator is installed. Observe the body of the camshaft position actuator for the "IN" marking (3). The marking is for an intake camshaft position actuator.
Ensure the proper timing mark is used. Observe the outer ring of the camshaft position actuator for the "R" and triangle marking (2). The marking is for alignment to the highlighted timing chain link on the right side of the engine.

Fig 1: Identifying Right Intake Camshaft Position Actuator
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice in Cautions and Notices.

Use an open wrench on the hex cast into the camshaft in order to prevent camshaft rotation when tightening the camshaft position actuator bolt.

Fig 2: View Of Camshaft Position (CMP) Actuator - Bank1 Intake

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the camshaft position actuator bolt.
Tighten: Tighten the camshaft position actuator bolt to 58 N.m (43 lb ft).