LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 3 Of 5)) >> Off-Vehicle Repair Instructions - Part 2 >> Intake Manifold Disassemble >> Upper Intake Manifold Disassemble Procedure

Upper Intake Manifold Disassemble Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Throttle Body
    GM1211064Courtesy of GENERAL MOTORS CORP.
  1. Remove the throttle body bolts.
  2. Remove the throttle body.
  3. Remove and discard the throttle body gasket.
    4. Fig 2: Removing & Installing Barometric Pressure Sensor Bolt
    GM1211071Courtesy of GENERAL MOTORS CORP.
  4. Remove the barometric pressure (BARO) sensor bolt.
  5. Remove the BARO sensor.
    6. Fig 3: Removing & Installing Communicator Valve
    GM1211080Courtesy of GENERAL MOTORS CORP.
  6. Remove the communicator valve bolts.
  7. Remove the communicator valve.
    8. Fig 4: Removing & Installing Sight Shield Ball Studs
    GM1318830Courtesy of GENERAL MOTORS CORP.
  8. Remove the sight shield ball studs.
    9. Fig 5: Removing & Installing Sight Shield Grommet
    GM1318832Courtesy of GENERAL MOTORS CORP.
  9. Remove the sight shield grommet.
scientia non olet · About LEMON Manuals