LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 3 Of 5)) >> Off-Vehicle Repair Instructions - Part 2 >> Camshaft Position (CMP) Actuator Removal - Right Intake

Camshaft Position (CMP) Actuator Removal - Right Intake

WARNING: This page is about a different variant/trim than selected.
NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice in Cautions and Notices.
  1. Use an open wrench on the hex cast into the camshaft in order to prevent engine rotation when loosening the camshaft position actuator bolt.
  2. Remove the right intake camshaft position actuator bolt.
    Fig 1: View Of Camshaft Position (CMP) Actuator - Bank1 Intake
    GM946228Courtesy of GENERAL MOTORS CORP.
  3. Remove the right intake camshaft position actuator.
scientia non olet · About LEMON Manuals