LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 3 Of 5)) >> Off-Vehicle Repair Instructions - Part 2 >> Camshaft Cover Assemble

Camshaft Cover Assemble

WARNING: This page is about a different variant/trim than selected.

Tools Required: 

J 24254  Oil Seal Installer

    Fig 1: Installing Ignition Coil Seals
    GM1211046Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW ignition coil seals using the J 24254  .
    2. Fig 2: Removing & Installing Camshaft Cover Gasket
    GM1211021Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW camshaft cover gasket.
    3. Fig 3: Removing & Installing Camshaft Cover Bolts
    GM1211016Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.
  3. Install the NEW camshaft cover bolt grommets.
  4. Install the camshaft cover bolts.
scientia non olet · About LEMON Manuals