Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- The ECM uses the camshaft position sensors to determine engine speed and position when there is a CKP sensor condition.
- The engine will operate with a CKP sensor condition only if the ECM has stored the learned reference position of the camshafts in memory. With a crankshaft position sensor condition other than a short to voltage in the signal circuit, the engine will go into a limp home mode after a hard restart. The ECM then calculates engine speed from one of the camshaft position sensors. During a limp home mode the following additional DTCs may set and should be ignored:
- DTC P0324 Knock Sensor (KS) Module Performance
- DTC P1011 Intake Camshaft Position Actuator Park Position Bank 1
- A short to voltage in the signal circuit of the CKP sensor will cause the engine to stall or not start and a DTC will not set.
- Refer to Symptoms - Engine Controls and Hard Start for further diagnosis.