LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls - 3.6L - Troubleshooting & Diagnosis) >> Troubleshooting >> Dieseling, Run-On

Dieseling, Run-On

WARNING: This page is about a different variant/trim than selected.
Dieseling, Run-On

Inspections Action
DEFINITION: The engine continues to run after the key is turned OFF, but runs very rough. If the engine runs smooth, inspect the ignition switch and the ignition switch adjustment.
Preliminary
  • Refer to Important Preliminary Checks Before Starting in Symptoms - Engine Controls .
  • Search for bulletins.
  • Verify that the engine control module (ECM) and ECM bracket fasteners are at the correct torque.
  • Inspect the engine control system grounds for being clean, tight, and in the correct locations. Refer to Power and Grounding Component Views in Wiring Systems and Engine Controls Schematics . Ensure the resistance between the ECM housing and the battery negative cable is less than 0.5 ohms.
Fuel System Test the fuel system for the following conditions:
  • High fuel system pressure
  • Leaking fuel injectors

    For more information, refer to Fuel System Diagnosis .
scientia non olet · About LEMON Manuals