LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Upper Intake Manifold Cover Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Engine Cover/Sight Shield
    GM1469395Courtesy of GENERAL MOTORS CORP.
  1. Remove the cross car brace, if necessary. Refer to Brace Replacement - Cross Vehicle in Body Front End.
  2. Remove the oil fill cap.
  3. Disengage the cover/shield from the ball studs by pulling up firmly on the rear and front of the engine cover.
  4. Remove the engine cover/sight shield.
    5. Fig 2: Removing & Installing Hood Seal & Passenger Side Air Inlet Screen Panel
    GM1559364Courtesy of GENERAL MOTORS CORP.
  5. Remove the hood seal from the passenger side air inlet screen panel.
  6. Remove the air inlet screen panel bolts (1).
  7. Remove the passenger side air inlet screen panel (3).
    8. Fig 3: Removing & Installing Air Inlet Housing Panel
    GM1559367Courtesy of GENERAL MOTORS CORP.
  8. Remove the air inlet housing panel bolt (3) and nuts (2).
  9. Remove the air inlet housing panel (1).
    10. Fig 4: Removing & Installing Rear Upper Intake Manifold Cover
    GM1459832Courtesy of GENERAL MOTORS CORP.
  10. Remove the nut from the rear stud.
  11. Remove the cover from the upper studs.
scientia non olet · About LEMON Manuals