LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Fuel Injector Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Engine Cover/Sight Shield
    GM1201042Courtesy of GENERAL MOTORS CORP.
  1. Position the engine cover/sight shield over the intake manifold so the grommets are aligned with the ball studs.
  2. Press the engine cover/sight shield down firmly near the ball studs in order to install the engine cover/sight shield.
  3. Install the cross car brace. Refer to Brace Replacement - Cross Vehicle in Body Front End.
scientia non olet · About LEMON Manuals