LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Engine Mount
    GM1283925Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the upper engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

    3. Fig 2: Identifying Frame Mounting Nuts
    GM785352Courtesy of GENERAL MOTORS CORP.
  3. Lower the engine using the jack screw until the weight is resting on the mount.
  4. Install the engine mount retaining nut.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

  5. Remove the screw jack and block of wood from under the oil pan.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals