LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Bracket Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Frame Mounting Nuts
    GM785352Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Install a screw jack with a block of wood under the oil pan for support.
  3. Remove the lower engine mount retaining nut.
  4. Raise the engine using the screw jack until the weight is removed from the mount.
    5. Fig 2: View Of Left Engine Mount
    GM1283928Courtesy of GENERAL MOTORS CORP.
  5. Remove the upper engine mount retaining nut.
  6. Remove the engine mount from the vehicle.
    7. Fig 3: Removing & Installing Left Engine Mount Bracket
    GM1283929Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure not to distort or bend the engine mount heat shield.
  7. Remove the left engine mount bracket retaining bolts.
  8. Remove the left engine mount bracket.
scientia non olet · About LEMON Manuals