LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Tensioner Replacement - Power Steering and Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Drive Belt Tensioner (Power Steering And Air Conditioning)
    GM887771Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt tensioner and bolt to the engine as an assembly.
  2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).

  4. Install the power steering and air conditioning drive belt. Refer to Drive Belt Replacement - Power Steering and Air Conditioning .
  5. Install the generator and water pump drive belt. Refer to Drive Belt Replacement - Generator and Water Pump .
scientia non olet · About LEMON Manuals