LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Replacement - Power Steering and Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Power Steering & A/C Drive Belt Routing
    GM1285183Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt to the crankshaft pulley, the idler pulley and the A/C compressor.
  2. Rotate the drive belt tensioner clockwise.
  3. Install the drive belt to the power steering pulley.
  4. Slowly release the drive belt tensioner.
    IMPORTANT: Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
  5. Install the generator and water pump drive belt. Refer to Drive Belt Replacement - Generator and Water Pump .
scientia non olet · About LEMON Manuals