LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Replacement - Generator and Water Pump >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Generator & Water Pump Drive Belt Routing
    GM1285186Courtesy of GENERAL MOTORS CORP.
  1. Rotate the drive belt tensioner clockwise to release the drive belt tension.
  2. Slide the drive belt off of the water pump pulley.
  3. Slowly release the drive belt tensioner.
  4. Remove the drive belt from the accessory drive pulleys.
scientia non olet · About LEMON Manuals