LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Drive Belt Idler Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Do not remove the generator and water pump belt.
  1. Remove the power steering and air conditioning drive belt from the power steering pump. Refer to Drive Belt Replacement - Power Steering and Air Conditioning .
    2. Fig 1: Removing & Installing Drive Belt Idler Pulley Bolt
    GM887775Courtesy of GENERAL MOTORS CORP.
  2. Remove the drive belt idler pulley bolt.
  3. Remove the drive belt idler pulley.
scientia non olet · About LEMON Manuals