Manual Downshifts
WARNING: This page is about a different variant/trim than selected.
The shift solenoid valves control the initial downshift for the 5-4, 4-3, 3-2 manual downshifts. The solenoid states should change during or shortly after a manual downshift is selected.
Manual 5-4 Downshift
- Place the gear selector in the OVERDRIVE position.
- Accelerate the vehicle to 64-88 km/h (40-55 mph) in FIFTH gear.
- Release the throttle while moving the gear selector to FOURTH.
- Verify the following:
- The TCC releases
- The transmission downshifts immediately to FOURTH gear
- The engine slows the vehicle
Manual 5-3 Downshift
- Place the gear selector in the OVERDRIVE position.
- Accelerate the vehicle to 64-72 km/h (40-45 mph).
- Release the throttle while moving the gear selector to THIRD.
- Verify the following:
- The TCC releases.
- The transmission downshifts immediately to THIRD gear.
- The engine slows the vehicle.
Manual 5-2 Downshift
- Place the gear selector in the OVERDRIVE position.
- Accelerate the vehicle to 48 km/h (30 mph).
- Release the throttle while moving the gear selector to SECOND.
- Verify the following:
- The TCC releases.
- The transmission downshifts immediately to SECOND gear.
- The engine slows the vehicle.