LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions >> Transmission Vent Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Vent Hose To Vent Pipe
    GM1426210Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose (2) to the vent pipe.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the shift guide plate bolt securing the vent hose (1) to the transmission.

    Tighten:  Tighten the shift guide plate bolt to 22 N.m (16 lb ft).

  3. Raise the jack.
  4. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  5. Remove the jack.
  6. Install the propeller shaft. Refer to Propeller Shaft Replacement (Automatic Transmission) , Propeller Shaft Replacement (Manual Transmission) or Propeller Shaft Replacement (CTS-V) in Propeller Shaft.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals