LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions >> Shift Control Shift Closeout Boot Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Shift Control Boot
    GM834523Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control boot and adaptor plate assembly to the vehicle.
    2. Fig 2: Installing 4 Nuts Securing Shift Control Adaptor Plate
    GM834521Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 nuts (1) securing the shift control adaptor plate to the tunnel reinforcement.

    Tighten:  Tighten the nuts to 12 N.m (106 lb in).

  3. Lift up on the shift control lever to bring the shift control assembly in contact with the shift control adaptor plate.
  4. Install the 2 bolts (2) securing the shift control assembly to the shift control adaptor plate.

    Tighten:  Tighten the bolts to 18 N.m (13 lb ft).

    5. Fig 3: Installing Electrical Connector To Shift Control Adaptor Plate
    GM834524Courtesy of GENERAL MOTORS CORP.
  5. Install the electrical connector (1) to the shift control adaptor plate (2).
    6. Fig 4: Installing Sound Insulator Foam Block Into Console
    GM834525Courtesy of GENERAL MOTORS CORP.
  6. Install the sound insulator foam block into the console.
  7. Install the shift control knob/boot assembly. Refer to Shift Control Knob Replacement .
scientia non olet · About LEMON Manuals