LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions >> Reverse Lockout Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the exhaust system. Refer to Exhaust System Replacement (LA3, LY9) , Exhaust System Replacement (LY7) and Exhaust System Replacement (LS6) in Engine Exhaust.
  3. Support the transmission with a suitable jack.
  4. Remove the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  5. Remove the transmission mount. Refer to Transmission Mount Replacement .
    6. Fig 1: Disconnecting Reverse Lockout Solenoid Electrical Connector
    GM1426253Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the reverse lockout solenoid electrical connector (5).
    7. Fig 2: Removing Bolt And Reverse Lockout Assembly
    GM1434394Courtesy of GENERAL MOTORS CORP.
  7. Using the J 41099  , remove the reverse lockout solenoid. See Special Tools and Equipment .
  8. Remove the bolt and the reverse lockout assembly, if necessary.
scientia non olet · About LEMON Manuals