LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - TREMEC 6-Speed) >> Repair Instructions >> Mainshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Remove The Transmission Case Extension Seal
    GM794670Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install the seal onto the tool before installing into the case to prevent damage to the seal.
  1. Using J 44765  install the new transmission case extension seal (1). See Special Tools and Equipment .
    2. Fig 2: Installing Drive Flange To Transmission Output Shaft
    GM1430041Courtesy of GENERAL MOTORS CORP.
  2. Install the drive flange to the transmission output shaft.
  3. Install a NEW drive flange thrust washer.
    4. Fig 3: View Of Flange Tool
    GM804354Courtesy of GENERAL MOTORS CORP.
  4. Install the J 45012  to the drive flange.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. While holding J 45012  , install a NEW drive flange nut using J 29873  .

    Tighten:  Tighten the drive flange nut to 57 N.m (42 lb ft).

  6. Remove the J 45012  from the drive flange.
    7. Fig 4: View Of Propeller Shaft Nounting Components
    GM1236100Courtesy of GENERAL MOTORS CORP.
  7. Install the propeller shaft (6). Refer to Propeller Shaft Replacement (Automatic Transmission) , Propeller Shaft Replacement (Manual Transmission) or Propeller Shaft Replacement (CTS-V) in Propeller Shaft.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals