Scan Tool Data List
WARNING: This page is about a different variant/trim than selected.
Use the scan tool data values under the following conditions:
- The Diagnostic System Check - Engine Controls is complete.
- The On-Board Diagnostics are functioning properly.
- No DTCs are present.
The values below represent a typical display recorded from a properly functioning system.
IMPORTANT:
Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.
Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.
Scan tool values below were recorded under the following conditions:
- Engine at idle
- Upper radiator hose hot
- Closed throttle
- Transmission in Neutral
- Closed Loop operation
- Accessories OFF
- Brake pedal not applied
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Clutch Pedal Switch | F0, F3 | applied/released | released |
| Reverse Inhibit Solenoid Command | F0 | INHIBIT/OFF | OFF |
| Skip Shift Lamp Command | F0 | ON/OFF | OFF |
| Skip Shift Solenoid Command | F0 | SKIP/NO SKIP | NO SKIP |
| TFT Sensor | F2 | °C/°F | 85-115°C (185-239°F) |
| Vehicle Speed Sensor | ALL | km/h (mph) | 0 |
*Data List Legend
|
|||