Test Description
WARNING: This page is about a different variant/trim than selected.
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step determines if the malfunction is present.
- 3: Using the Freeze Frame/Failure Records data may aid in locating an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame/Failure Records data can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can also help determine how many ignition cycles the diagnostic reported a pass and/or a fail. Operate the vehicle within the same freeze frame conditions, such as RPM, load, vehicle speed, temperature, that you observed. This will isolate when the DTC failed.
- 4: A TFT below -30°C(-22°F) indicates that the PCM and TFT sensor wiring if functioning correctly.
- 5: Disconnecting the PCM enables the DMM to test continuity of the circuits. This aids in locating an open or a shorted circuit.
- 7: Inspect for proper terminal tension/connections at the PCM harness before replacing the PCM.
DTC P0712
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check - Engine Controls? | - | Go to Step 2 | Go to Diagnostic System Check - Engine Controls in Engine Controls - 5.7L |
| 2 |
|
150°C (302°F) | Go to Step 4 | Go to Step 3 |
| 3 |
|
- | Go to Step 4 | Go to Diagnostic Aids |
| 4 |
|
-30°C (-22°F) | Go to Step 6 | Go to Step 5 |
| 5 |
|
- | Go to Step 8 | Go to Step 7 |
| 6 | Replace the TFT sensor. Refer to Transmission Fluid Temperature (TFT) Sensor Replacement . Is the action complete? |
- | Go to Step 8 | - |
| 7 | Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement
in Engine Controls - 5.7L. Is the action complete? |
- | Go to Step 8 | - |
| 8 | Perform the following procedure in order to verify the repair:
Has the test run and passed? |
- | Go to Step 9 | Go to Step 2 |
| 9 | With the scan tool, observe the stored information, capture info and DTC info. Does the scan tool display any DTCs that you have not diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List in Engine Controls - 5.7L | System OK |