Installation Procedure
- Install the I/P retainer onto the I/P carrier.
- Install the upper I/P retainer screws.
- Connect the air temperature sensor and the aspirator tube.
- Connect the passenger side inline connector.
- Install the screws securing the retainer to the I/P carrier.
Tighten: Tighten the fasteners to 9 N.m (80 lb in).
- Install the screws behind the I/P compartment securing the I/P retainer to the I/P carrier.
Tighten: Tighten the screws to 9 N.m (80 lb in).
- Install the screws securing the lower center stack.
Tighten: Tighten the screws to 9 N.m (80 lb in).
- Install the fasteners securing the side of the retainer the center support.
Tighten: Tighten the fasteners to 9 N.m (80 lb in).
- Install the bolts securing the lower retainer support bracket.
Tighten: Tighten the fasteners to 25 N.m (18 lb ft).
- Raise the steering column. Refer to Steering Column Replacement in Steering Wheel and Column.
- Install the left and right I/P closeout panel. Refer to Closeout/Insulator Panel Replacement - Right and Closeout/Insulator Panel Replacement - Left .
- Install the defroster grille. Refer to Defroster Grille Replacement .
- Install the I/P cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
- Install the I/P compartment assembly. Refer to Compartment Replacement - Instrument Panel (I/P) .
- Install the radio assembly. Refer to Radio Replacement in Entertainment.
- Install the upper A/C vents.
- Install the center console. Refer to Console Replacement - Front Floor .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
Fig 3: Removing & Installing Instrument Panel Retainer-To-Instrument Panel Carrier Screws (Behind Instrument Panel Compartment)