Installation Procedure
- Install the carrier assembly.
- Install the bolts securing the carrier to the cowl.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
- Install the nuts securing the carrier to the firewall under the A pillar.
Tighten: Tighten the nuts to 9 N.m (80 lb in).
- Connect all electrical wire retainers to the carrier assembly.
- On vehicles with a manual shift transmission, loosen the nuts (2) on the pedal bracket.
Tighten: Tighten the nuts to 25 N.m (18 lb ft).
- Install the parking brake pedal assembly. Refer to Park Brake Pedal Assembly Replacement (LHD)Park Brake Pedal Assembly Replacement (RHD) in Park Brake.
- Install the 2 nuts (1) securing the brake pedal bracket to the cowl.
Tighten: Tighten the nuts to 25 N.m (18 lb ft).
- Install the HVAC ducts. Refer to Air Outlet Duct Replacement - Instrument Panel (I/P) - Upper Left , Air Outlet Duct Replacement - Instrument Panel (I/P) - Upper Right , andDefroster Duct Replacement - Windshield in Heating, Ventilation and Air Conditioning.
- Install the I/P retainer. Refer to Instrument Panel (I/P) Retainer Replacement .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.