Chime Always On
Chime Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Audible Warnings Schematics Connector End View Reference: Body Control System Connector End Views or to Inline Harness Connector End Views |
|||
| 1 | Did you perform the Audible Warnings Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Audible Warnings |
| 2 | Are any indicators illuminated? | Go to Symptoms - Instrument Panel, Gages and Console | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 4 |
|
Go to Step 6 | Go to Step 5 |
| 5 | Test the ignition key alarm switch signal circuit for a short to ground. Refer to Circuit Testing
and to Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 7 |
| 6 | Inspect for poor connections at the harness connector of the key switch. Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 8 |
| 7 | Inspect for poor connections at the harness connector of the Dash Integration Module (DIM). Refer to Testing for Intermittent Conditions and Poor Connections
and to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 10 | Go to Step 9 |
| 8 | Replace the ignition switch. Refer to Ignition Switch Replacement
in Steering Wheel and Column. Did you complete the replacement? |
Go to Step 10 | - |
| 9 |
IMPORTANT:
Program the replacement DIM. Replace the DIM. Refer to Dash Integration Module Replacement
in Body Control System.Did you complete the replacement? |
Go to Step 10 | - |
| 10 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |