LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Seville STS >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag Restraint Systems >> Disabling & Activating Air Bag System >> Disabling System >> Zone 9

Zone 9

  1. Turn steering wheel to place vehicle wheels in straight-ahead position. Turn ignition off and remove key.
  2. Remove rear seat. See REAR SEAT CUSHION  under REMOVAL & INSTALLATION. Remove SIR fuse (15-amp) from fuse block, located under left rear seat cushion. See Figure.
  3. If disabling passenger side impact air bag module and seat belt pretensioner, complete this step. If disabling entire air bag system, complete all steps. Remove CPA clips from passenger side impact air bag module and seat belt pretensioner connector, located under passenger-side front seat. See Figure. Disconnect connectors.
  4. Remove passenger-side knee bolster. Remove CPA clip from passenger-side air bag module connector. See Figure. Disconnect connector.
  5. Remove driver-side knee bolster. Remove CPA clip from driver-side air bag module connector. See Figure. Disconnect connector.
  6. Remove CPA clips from driver side impact air bag module and seat belt pretensioner connectors, located under driver seat. See Figure. Disconnect connectors.
scientia non olet · About LEMON Manuals