LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Escalade ESV >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Engine Mechanical (Repair Instructions -- 1 Of 3) -- 4.8L, 5.3L & 6.0L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the right engine mount to the engine.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount bolts.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

    3. Fig 1: View Of Right Engine Mount & Bolts
    GM307279Courtesy of GENERAL MOTORS CORP.
  3. Lower the engine.
  4. Remove the adjustable jack stands.
  5. Install the engine mount-to-engine mount bracket bolts.

    Tighten:  Tighten the engine mount-to-engine mount bracket bolts to 65 N.m (48 lb ft).

    6. Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  6. Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right (4.8L, 5.3L, and 6.0L Engines) in Engine Exhaust.
  7. Install the inner wheelhouse panel. Refer to Refer to Wheelhouse Panel Replacement in Body Front End.
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals