LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> CTS Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Steering Column - Tilt >> Repair Instructions >> Ignition Switch Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the inflatable restraint steering wheel module.
  2. Remove the theft deterrent control module. Refer to THEFT DETERRENT CONTROL MODULE REPLACEMENT in Theft Deterrent.
  3. Rotate the key alarm connector (1) 90 degrees.
  4. Gently pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).
    Fig 1: Key Alarm Connector Of Ignition Lock Cylinder Case Assembly
    G02085576Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the connector from the ignition switch assembly.
  6. Remove the wires encased in the ignition switch clip (located on the side of the ignition switch).
  7. Remove the ignition switch assembly (2) using J 42759  . See Special Tools and Equipment .
    Fig 2: Ignition Switch Assembly
    G02085577Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals