Installation Procedure
- When installing a new lock cylinder, code the lock cylinder to the vehicle key.
- Insert the key into the lock cylinder assembly (2).
- Insert the lock cylinder into the IP storage compartment door handle (1).
Align the lock cylinder to the latch handle in the same position observed during removal.
- Push the lock cylinder (2) toward the IP compartment latch handle in order to fully seat the lock cylinder to the IP storage compartment latch handle (1).
- Turn the key 1/4 turn counterclockwise in order to secure the lock cylinder (2) to the IP storage compartment latch handle (1).
- Turn the key an additional 1/4 turn counterclockwise and remove the key from the lock cylinder.
Important: The lock cylinder should only turn a 1/4 turn and should be securely retained to the IP compartment latch handle when installed.
- Inspect the lock cylinder for proper operation.
- Engage the handle/latch actuator cable (1) to the IP storage compartment latch.
- Install the IP compartment latch handle (2) to the IP storage compartment door.NOTE: Refer to FASTENER NOTICE .
- Install the IP storage compartment latch handle screws (1).
Tighten
Tighten the screws (1) fully driven, seated, but not stripped.
- Install the IP storage compartment door trim plate (2).
- Install the screws (1) to the IP storage compartment door trim panel (2).
Tighten
Tighten the screws (1) fully driven, seated, but not stripped.
- Lift the IP storage compartment door in order to install the IP storage compartment door compensator.
- Install the end of the IP compartment door compensator rod into the IP storage compartment door, and twist the compensator rod 1/4 turn in order to secure the IP compartment door compensator rod to the IP storage compartment door.
- Close the IP storage compartment door.
- Inspect the IP storage compartment/latch for proper operation.