LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Seville STS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

NOTE: Refer to FASTENER NOTICE .
  1. Align the knee bolster bracket (3) to the lower IP, then install the knee bolster fasteners (2).

    Tighten 

    Tighten the fasteners (2) to 9 N.m (80 lb in).

  2. Install the DLC to the knee bolster.
  3. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster 
  4. Install the left sound insulator. Refer to Closeout/Insulator Panel Replacement - Left (LHD)  or Closeout/Insulator Panel Replacement - Left (RHD)  or Closeout/Insulator Panel Replacement - Right (LHD)  or Closeout/Insulator Panel Replacement - Right (RHD) 
    Fig 1: Installing Fasteners & Knee Bolster Bracket
    G01796270Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals