LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Seville STS >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Instrument Panel (I/P) Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Install the IP assembly (3) to the vehicle.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the IP assembly to hinge pillar bolts (2).

    Tighten 

    Tighten the IP carrier bolts (2) to 25 N.m (18 lb ft).

    Fig 1: Installing IP Assembly & Bolts
    G01796356Courtesy of GENERAL MOTORS CORP.
  3. Install the IP carrier to cowl nuts (1).

    Tighten 

    Tighten the IP carrier to cowl nuts (1) to 25 N.m (18 lb ft).

    Fig 2: Installing IP Carrier & Cowl Nuts
    G01796357Courtesy of GENERAL MOTORS CORP.
  4. Install the IP extension bolts (1).

    Tighten 

    Tighten the IP extension bolts (1) to 25 N.m (18 lb ft).

    Fig 3: Installing IP Extension & Bolts
    G01796358Courtesy of GENERAL MOTORS CORP.
  5. Install the steering column support bolts (1). Refer to STEERING WHEEL REPLACEMENT .
  6. Install the steering shaft to the steering column. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT .
    Fig 4: Installing Steering Column & Body Bolts
    G01796359Courtesy of GENERAL MOTORS CORP.
  7. Remove the J 42640  from the steering column.
    Fig 5: Removing J 42640 & Steering Column
    G01796360Courtesy of GENERAL MOTORS CORP.
  8. Connect the steering column main harness electrical connector (1).
    Fig 6: Connecting Steering Column Main Harness Electrical Connector
    G01796361Courtesy of GENERAL MOTORS CORP.
  9. Connect the tilt and telescoping module electrical connector (1), if equipped.
    Fig 7: Connecting Tilt & Telescoping Module Electrical Connector
    G01796362Courtesy of GENERAL MOTORS CORP.
  10. Connect the body harness electrical connector (1) and the audio antenna connection (2).
    Fig 8: Connecting Body Harness Electrical Connector
    G01796363Courtesy of GENERAL MOTORS CORP.
  11. For RHD, Install the park brake cable to the park brake pedal assembly. Refer to PARK BRAKE CABLE (FRONT) .
    Fig 9: Installing Park Brake Cable & Park Brake Pedal Assembly
    G01796364Courtesy of GENERAL MOTORS CORP.
  12. Connect the IP to body electrical connectors (1) at top outside corners of IP.
  13. Install the defroster grille. Refer to Defroster Grille Replacement 
  14. Install the IP upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper 
  15. Install the drivers knee bolster bracket. Refer to Knee Bolster Replacement 
  16. Install the floor console. Refer to Console Replacement (w/o UV8)  or Console Replacement (with UV8) 
  17. Install the left and right IP outer trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement 
  18. Enable the SIR. Refer to ACTIVATING SYSTEM .
    Fig 10: Connecting IP To Body Electrical Connectors
    G01796365Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals