Installation Procedure

Slide the insulator (2) over the top of the emergency brake bracket (1).

Fig 1: Installing Insulator, Park Brake Bracket & Insulator Closeout/Insulator Panel Replacement - Left (LHD)
Courtesy of GENERAL MOTORS CORP.
Reconnect the electrical connectors (1,3).

Fig 2: Connecting Electrical Connectors & Insulator Closeout/Insulator Panel Replacement - Left (LHD)
Courtesy of GENERAL MOTORS CORP.
Set the forward edge of the insulator onto the shelf of the carpeting at the front of the vehicle.
Align the insulator with the floor duct at the HVAC module.
Align the snap tab fasteners with the lower IP and push the insulator upward in order to engage the fasteners.
NOTE: Refer to FASTENER NOTICE .
Install the insulator fasteners (1) into lower IP.
Tighten

Tighten the fasteners to 2 N.m (18 lb in).

Fig 3: Installing Fasteners & Closeout/Insulator Panel Replacement - Left (LHD)
Courtesy of GENERAL MOTORS CORP.