Removal Procedure
CAUTION:
Refer to SIR HANDLING CAUTION
.
- Disable SIR. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
- Remove the floor console. Refer to Console Replacement (w/o UV8) or Console Replacement (with UV8)
- Remove the drivers knee bolster. Refer to Knee Bolster Replacement
- Remove the IP outer trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement
- Remove the IP upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper
- Remove the defroster grille. Refer to Defroster Grille Replacement
- Disconnect the body to IP electrical connectors (1) at the top, outside corners of IP.
- For RHD only, remove the park brake cable from the park brake pedal assembly. Refer to PARK BRAKE CABLE (FRONT) .
- With the steering wheel centered, install the J 42640 in order to lock the steering column.
- Remove the steering column to body bolts (1). Refer to STEERING WHEEL REPLACEMENT .
- Disconnect the steering shaft from the steering gear. Refer to INTERMEDIATE STEERING SHAFT REPLACEMENT .
- Disconnect the steering column harness connector (1).
- Disconnect the electrical connector (1) for the tilt and telescoping module, to the main body harness, if equipped.
- Disconnect the body harness connection (1) and the audio antenna connection (2), which are located next to the IP extension.
- Remove the IP extension bolts (1).
- Remove IP carrier to cowl nuts (1).
- Remove the bolts (2) from the left and right IP carrier to hinge pillar.
- Remove the IP assembly (3) from the vehicle.