LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Trim Panel Replacement - Instrument Panel (IP) Upper >> Installation Procedure

Installation Procedure

  1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
    2. Fig 1: Installing Electrical Connector to Ambient Light Sensor
    G01697237Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel to the IP assembly.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the trim panel retaining screws. Tighten the trim panel retaining screws to 2 N.m (18 lbs in).
  4. Install the windshield pillar garnish moldings. Refer to GARNISH MOLDING REPLACEMENT - WINDSHIELD PILLAR .
    5. Fig 2: Installing Trim Panel to IP Assembly
    G01697238Courtesy of GENERAL MOTORS CORP.
  5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
  6. Install the right side air outlets.
    7. Fig 3: Installing Garnish Molding
    G01697239Courtesy of GENERAL MOTORS CORP.
  7. Install the end panels. The left panel is shown, and the right panel is similar.
  8. Install the IP cluster trim plate bezel. Refer to Bezel Replacement - IP Cluster .
  9. Tilt the steering wheel to the normal driving position.
  10. If the transmission is automatic, move the shift lever to the park position.
  11. Disengage the parking brake.
    12. Fig 4: Installation of Trim Plate Bezel
    G01697240Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals