Installation Procedure
- Slide the extension forward and onto the upper fasteners.
- Install the bolts attaching the console extension to the IP. Tighten the bolts to 2 N.m (18 lbs in).
- Install the console extension upper compartment insert.
- Install the remote CD player, if equipped. Refer to REMOTE CD PLAYER REPLACEMENT
.
- Install the trim bezel. Tighten the screws to 2 N.m (18 lbs in).
Courtesy of GENERAL MOTORS CORP.
- Position the center console on the bracket (2).
- Install the screws attaching the center console to the console extension. Tighten the screws to 2 N.m (18 lbs in).
Courtesy of GENERAL MOTORS CORP.
- Install the cupholder by push until the unit locks into place.
Courtesy of GENERAL MOTORS CORP.
- Install the 4 retaining bolts to the bracket. Tighten the bolts to 3.5 N.m (31 lbs in).
- Close the console door.
Courtesy of GENERAL MOTORS CORP.