Installation Procedure

NOTE: The ashtray lid (1) and cupholder lid (2) must be in the open position.

Open the ashtray lid (1) and cupholder lid (2).
Partially install the bezel.
Connect the electrical connectors.
Install the lower bezel to the console.
Push on the corners until the retainers are fully seated in place.

Fig 1: Installing Ashtray & Cupholder Lids

G01697335

Courtesy of GENERAL MOTORS CORP.

Align the locating pins (1) on the upper bezel.
Press in on the bezel until all retaining clips are fully seated.

Fig 2: Installing Floor Console Upper Bezel

G01697336

Courtesy of GENERAL MOTORS CORP.