LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Anti-Lock Brake System >> Repair Instructions >> Brake Pressure Modulator Valve (BPMV) Replacement (w/o JL4) >> Installation Procedure

Installation Procedure

NOTE: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
  1. Install the EBCM (2) onto BPMV (1).
  2. Install the four EBCM bolts. Tighten the 4 bolts to 5 N.m (39 lbs in) in an X-pattern.
    NOTE: Do not reuse the old mounting bolts. Always install new EBCM bolts with the new BPMV.
  3. Connect the 2 way ABS pump motor connector to the EBCM.
  4. Install the BPMV (1) to EHCU bracket (3).
  5. Install the BPMV (1) to bracket retaining bolts (4). Tighten the bolts to 9 N.m (7 lbs ft).
    6. Fig 1: Installation Of EBCM Onto BPMV
    G01664072Courtesy of GENERAL MOTORS CORP.
  6. Install the EHCU to the vehicle frame (5). Tighten the three EHCU bracket bolts (4) to 25 N.m (18 lbs ft).
  7. Connect the 2 electrical harness connectors to the EBCM (1).
    NOTE: The brake pipes are held in place by a plastic bracket mounted to the frame. Make sure that the brake pipes stay in the correct place for proper reassembly.
    8. Fig 2: Installing EHCU Bracket Bolts & Electrical Connectors To EBCM
    G01664073Courtesy of GENERAL MOTORS CORP.
  8. Install the 5 brake pipes to the BPMV (6). Tighten the brake pipe fittings to 25 N.m (18 lbs ft).
  9. Bleed the brake system. Refer to MANUAL BLEEDING or PRESSURE BLEEDING in Hydraulic Brakes before proceeding.
  10. Bleed the brake system. Refer to ABS Automated Bleed Procedure (w/JL4)  or ABS Automated Bleed Procedure (w/o JL4)  .
scientia non olet · About LEMON Manuals