Diagnostic Aids

The traction control system can be controlled by the operator in the following ways:

• Through operation of the traction control switch.
• Through programming of the traction control system automatic engagement feature.

Depending on the programmed state, the operation of the traction control system, as well as the operation of the traction off and low traction indicators, differs. For a more detailed explanation of these operational characteristics, refer to Traction Control Indicator Lamps in ABS Description and Operation .

Observe the data list parameters listed below in order to determine the status of the traction control system when it is unknown if the system is operational.

• Traction Control Enabled.
• Traction Off Lamp Command.

Press the traction control switch and observe the scan tool in order to verify a change in the status of the data list parameters.

Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS .