LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Door Body Side (Tahoe/Yukon) >> Removal Procedure

Removal Procedure

    Fig 1: Door Body Side Molding
    GM521819Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Be careful not to scratch or chip the paint.
  1. Heat the body side molding using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface.

    Apply heat using a circular motion for about 30 seconds.

  2. Starting from one end of the molding, peel off the molding from the panel surface using a flat-bladed tool.
  3. Remove all adhesive from the body panel using a 3M™ scotch brite molding adhesive remover disk P/N 07501 or equivalent.
scientia non olet · About LEMON Manuals