LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Hinge Replacement - Rear Cargo Door - Upper Body Side >> Installation Procedure

Installation Procedure

    Fig 1: Preparing Pillar Surfaces
    GM637636Courtesy of GENERAL MOTORS CORP.
  1. Clean and prepare the pillar surfaces in order to ensure a flush fit of the service hinge and the fasteners.
    2. Fig 2: Applying Caulk To Entire Hinge Mounting Surface
    GM637639Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Prior to refinishing, refer to GM 4901MD-99 Refinish Manual for recommended products. Do not combine paint systems. Refer to paint manufacturer's recommendations.
  2. Apply an approved anti-corrosion primer.
  3. Apply full-body caulk to the entire hinge mounting surface.
    4. Fig 3: Installing Rear Cargo Door Hinge (Upper Body Side)
    GM637641Courtesy of GENERAL MOTORS CORP.
  4. Position the service hinge within the scribe marks on the pillar.
    5. NOTE: Refer to FASTENER NOTICE .
  5. Install the hinge fasteners.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  6. Refinish the metal surfaces as necessary.
  7. Align and install all of the related panels and the components.
scientia non olet · About LEMON Manuals