LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Door Striker Replacement - Body Mounted Rear >> Installation Procedure

Installation Procedure

    Fig 1: Installing Body Mounted Rear Door Striker
    GM570308Courtesy of GENERAL MOTORS CORP.
  1. Install the striker to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the striker screws.

    Tighten:  Tighten the screws to 25 N.m (18 lb ft).

  3. Install the upper garnish trim panel. Refer to Garnish Molding Replacement - Rear Door Frame .
scientia non olet · About LEMON Manuals