LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Escalade EXT >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Front Fender Rear (Avalanche) >> Removal Procedure

Removal Procedure

    Fig 1: Front Fender Rear Molding (Avalanche)
    GM741424Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When this molding is removed, all retaining clips need to be replaced with new clips if the molding is to be reused.
  1. Grasp the lower part of the molding.
  2. Pull outwards in order to release the retainers from the body panel.
    3. IMPORTANT: Do not scratch or chip the paint.
  3. Remove all adhesive from the fender and the back of the molding using a 3M™ Scotch Brite molding adhesive remover disc, 3M P/N 07501 or equivalent.
  4. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
scientia non olet · About LEMON Manuals