Steering Column Tilt Head Housing - Disassemble - Off Vehicle

Tools Required

• J 23653-SIR Steering Column Lock Plate Compressor
• J 42137  Cam Orientation Plate Adapter

Fig 1: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to SIR CAUTION in Cautions and Notices.
1. Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM in SIR.
IMPORTANT: Let the inflatable restraint steering wheel module coil hang freely after removal.
2. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift) .
3. Compress the cam orientation plate using J 23653-SIR and J 42137  .
4. Remove the bearing retainer using J 23653-SIR and J 42137  from the steering column shaft assembly.
5. Remove J 23653-SIR and J 42137  from the steering column shaft assembly.
6. Discard the bearing retainer.
Fig 2: Removing The Tilt Head From The Steering Shaft (Standard)
Courtesy of GENERAL MOTORS CORP.
7. Remove the following parts from the steering column shaft assembly:
   1. The cam orientation plate (5)
   2. The turn signal cancel cam assembly (4)
   3. The upper bearing spring (3)
   4. The upper bearing inner race seat (2)
   5. The inner race (1)