LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Eldorado ESC >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Electronic Suspension System - Road Sensing Suspension >> Repair Instructions >> Rear Position Sensor Replacement - Electronic Suspension >> Installation Procedure

Installation Procedure

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the position sensor on the vehicle with two screws.

    Tighten 

    Tighten two screws to 9 N.m (80 lb in).

  2. Connect the sensor link to the ball stud.
  3. Connect the three sensor harness clips onto the vehicle.
  4. Connect the sensor harness connector to the vehicle harness connector.
  5. Install the wheel onto the vehicle. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  6. Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  7. Inspect the Trim Height. Refer to TRIM HEIGHT INSPECTION PROCEDURE .
    Fig 1: Rear Position Sensor
    G01652009Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals