LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2002 >> Eldorado ECS >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - General Diagnosis >> Repair Instructions >> Memory Steer

Memory Steer

NOTE: The steering wheel does not return to center after completing a turn.
  1. Did you review the General Description and perform the necessary inspections? If so, go to step  2. If not, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
  2. Verify that memory steer is present. Does the system operate normally? If so, system is OK. If not, go to step  3.
  3. Ensure that all of the tires are inflated to the correct pressure. Has the inspection/adjustment been performed? If so, go to step  4.
  4. Lubricate the tie rod ends and the ball joints if applicable. Inspect the suspension system for worn or damaged components. Repair as necessary. Road test the vehicle in order to verify the customer complaint. Does the vehicle still exhibit memory steer? If so, go to step  5. If not, system is OK.
  5. Check for proper wheel alignment. Refer to MEASURING WHEEL ALIGNMENT in SPECIFICATIONS . Adjust as necessary. Road test the vehicle in order to verify the customer complaint. Does the vehicle still exhibit memory steer? If so, go to step  6. If not, system is OK.
  6. Raise and support the vehicle. Disconnect both of the outer tie rod ends from the steering knuckles. Use your hands in order to move the tie rod ends. Are either of the tie rod ends abnormally difficult to move? If so, go to step  7. If not, go to step  8.
  7. Replace the outer tie rod ends as necessary. After repairs are complete, go to step  17.
  8. Inspect for binding strut bearings and lower ball joints. Use your hands to push and pull the front of the wheels inboard and outboard. Are either of the struts abnormally difficult to move? If so, go to step  10. If not, go to step  9.
  9. Remove the tire/wheel. Disconnect the strut from the steering knuckle. Use your hands to rotate the strut. Is the strut abnormally difficult to rotate? If so, go to step  10. If not, go to step  11.
  10. Replace the strut bearing. Refer to STRUT, STRUT COMPONENT AND/OR SPRING REPLACEMENT in FRONT SUSPENSION . After repairs are complete, go to step  17.
  11. Use your hands in order to rotate the steering knuckle/ball joint. Is the steering knuckle/ball joint abnormally difficult to rotate? If so, go to step  12. If not, go to step  13.
  12. Replace the lower control arm. Refer to LOWER CONTROL ARM REPLACEMENT in FRONT SUSPENSION . After repairs are complete, go to step  17.
  13. Raise and support the vehicle. Rotate the steering wheel ONE revolution in either direction. Rotate the steering wheel back to the original position. Was the steering wheel abnormally difficult to rotate in either direction? If so, go to step  14. If not, go to step  17.
    1. Disconnect the intermediate shaft.
      NOTE: Do NOT rotate the steering wheel more than one complete revolution.
    2. Note the position of the steering wheel and rotate the steering wheel ONE revolution in either direction.
    3. Rotate the steering wheel back to the original position as previously noted.
    Was the steering wheel abnormally difficult to rotate in either direction? If so, go to step  16. If not, go to step  15.
  14. Repair the steering gear as necessary. Refer to POWER STEERING GEAR REPLACEMENT . Road test the vehicle in order to verify the customer complaint. After repairs are complete, go to step  17.
  15. Repair the steering column as necessary. After repairs are complete, go to step  17.
  16. Operate the vehicle in order to verify the repair. Did you correct the condition? If so, system is OK. If not, go to step  3.