Hydraulic Brake Booster Accumulator: Notes
WARNING:
The accumulator contains compressed gas. Always use the proper tools and follow the recommended procedures or personal injury may result. Do not apply heat to accumulator. Do not attempt to repair an inoperative accumulator. Always replace an inoperative accumulator with a NEW one. Dispose of an inoperative accumulator by drilling a 1.5 mm (1/16 in) diameter hole through the end of the accumulator can, opposite the O-ring.
CAUTION:
Push rod removal is not recommended. Improper staking of the push rod to the Hydro-boost reaction piston can result in a loss of brakes. If the rod or seals require service, the entire unit must be replaced.