Park Brake Shoe Inspection
- Raise and suitably support the vehicle.
- Remove the rear brake rotor. See REAR BRAKE ROTOR
under REMOVAL & INSTALLATION.
- Inspect and replace the park brake shoe and lining if any of the following conditions are found:
- Excessive wear indicated by the park brake lining being worn down to the shoe.
- Brake lining cracking.
- Oil or fluid contamination.
- Adjust the park brake shoes if necessary. See PARKING BRAKE
located in this section.
- Install the rear brake rotor. See REAR BRAKE ROTOR
under REMOVAL & INSTALLATION.
- Lower the vehicle.