Test K: Charge Indicator Inoperative
- If engine electrical diagnostic system check has been performed, go to next step. If engine electrical diagnostic system check has not been performed, perform ENGINE ELECTRICAL DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Turn ignition switch to RUN position. Observe charge indicator during 5 second bulb check. If charge indicator does not illuminate during bulb check, go to next step. If charge indicator illuminates during bulb check, inspect for intermittents. See TROUBLE SHOOTING .
- Replace Instrument Panel Cluster (IPC), then go to next step.
- Operate system to verify repair. If system is not operating correctly, repeat test beginning at step 2 .