Tire Pressure Monitor (W/UJ6)

The tire pressure parameter is supplied by the remote keyless entry (RKE) module to the IPC via class 2 serial data messages. The tire pressure parameter cannot be reset by the driver. The tire pressure is displayed on the DIC in one of the following formats (the XX represents the supplied tire pressure value):

• XX PSI LF TIRE OK, LOW or HIGH
• XX kPa LF TIRE OK, LOW or HIGH
• XX PSI RF TIRE OK, LOW or HIGH
• XX kPa RF TIRE OK, LOW or HIGH
• XX PSI LR TIRE OK, LOW or HIGH
• XX kPa LR TIRE OK, LOW or HIGH
• XX PSI RR TIRE OK, LOW or HIGH
• XX kPa RR TIRE OK, LOW or HIGH

The units of the display will correspond to the current instrument cluster setting.