LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2000 >> Escalade >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Front Suspension - 4WD Torsion Bar - "K" Series - New Style) >> Removal & Installation >> Upper Control Arm Bushings >> Bushing Replacement

Bushing Replacement

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2000 GMC Yukon XL, 2000 GMC Yukon, 2000 GMC Sierra, 2000 Chevrolet Tahoe, and 2000 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove upper control arm from vehicle. See UPPER CONTROL ARM . Place upper control arm in soft-jaw vise.
  2. Press bushings out of upper control arm.
    NOTE: Alignment angles are preset at factory. Knockouts must be removed before installation of alignment adjustment cams using Knockout Removal Tool (J-38794).
  3. Press NEW bushings into upper control arm.
  4. Ensure bushings are properly seated in upper control arm. Install upper control arm. See UPPER CONTROL ARM .
scientia non olet · About LEMON Manuals